This thermal oil furnace is heated by multiple barrel bodies in series, and the oil inlet of the furnace is forcibly circulated by a high lift oil pump. The equipment is equipped with one oil inlet and one oil outlet, both connected by flanges. Install a tee at the oil inlet to facilitate the expansion of the heat transfer oil after initial oil injection and heating. The thermal oil furnace heater has a power density of less than 3W and a designed service life of 10-15 years. Please pay attention to maintenance and repair during use. To ensure the normal operation of thermal oil furnace products.

A heat transfer oil furnace is an efficient and energy-saving heating equipment that uses heat transfer oil as a carrier and forcibly circulates the heated high-temperature heat transfer oil through a hot oil pump to transfer it to the heating body (heating equipment). It can achieve a higher working temperature under lower pressure. The heater is directly installed in the heat transfer oil for heating, with closed loop heating and minimal heat loss. If the buyer adopts a one-on-one heating process, the energy-saving effect is more obvious and can meet the precise control of temperature at various points within the highest design temperature

What are the techniques for using high-temperature thermal oil furnaces?

The heat transfer oil is put into use. At the beginning of operation, the circulating oil pump should be started to run normally for half an hour before igniting and heating up. During initial use, the temperature should be slowly increased by about 20 degree per hour. When the temperature rises to around 130 degree , it should be kept warm for a period of time. When the temperature rises to 180 degree ~200 degree , it should be kept warm for another period of time before it can be put into normal use.

When using a high-temperature heat transfer oil furnace, it should be carefully checked to strictly prevent water, acid, alkali, and low boiling substances from leaking into the operating system. A filtering device should be installed to prevent mechanical debris from entering the system and ensure the purity of the oil. High temperature heat transfer oil is suitable for coal-fired, gas, and oil-fired heating furnaces as carriers. When using heating equipment such as electric heating reactors, it should have expansion tanks, oil storage tanks, other safety components, and temperature control instruments to ensure safe operation. When replacing the heating system with a new heat transfer oil, a cleaning agent must be used to clean the pipeline and eliminate impurities on the inner wall to avoid affecting the heat transfer efficiency and service life of the heat transfer oil. The above is our Hongchuang's years of experience in using thermal oil furnaces.